Căutare după Titlu
Afișează articolele 2760-2779 of 2993
-
The Importance of Using Membranes in Seawater Desalination as a Result of Excessive Exploitation of Water Sources
(Universitatea "Dunărea de Jos" din Galați, 2017)This paper is a detailed study of the need to find and implement new solutions for water filtration and the promotion of modern techniques that are more effective than traditional methods. As a result of extension waste ... -
The Impulsive Loading Influence on Dynamic Response Parameters of the Viaduct Type Structure
(Universitatea "Dunărea de Jos" din Galați, 2011)Bridges and viaducts are vital structures ensuring ways of communication, so they must be protected from dynamic loads from traffic or seismic activity. For this reason are embedded in their structure dynamic isolation systems ... -
The Inclusion in the Calculation Schemws for Numerical Simulation of the Pressures Drop on Inlet and Outlet of Hydraulic circuits
(Universitatea "Dunărea de Jos" din Galați, 2014)Numerical simulation of the operation of hydraulic systems acting on hydraulic cylinderst is based on differential equations that describe the equilibrium of forces and the continuity of the flow rate. To simplify ... -
The Influence of Biodiesel Fuels on Lubricity of Passenger Car Diesel Engine Oils
(UDJG, 2010)The present paper mainly focuses on the physical and chemical impact of currently used and future biodiesel components on the performance of a typical low-sulphated-ash-phosphorus-sulphur (low SAPS) passenger car engine ... -
The Influence of Cold Rolling on the Mechanical Characteristics for Drawing Steels
(Universitatea "Dunărea de Jos" din Galaţi, 2008)The paper presents the changes of the mechanical and technological characteristics of steel for deep drawing, cold rolled and recrystallization heat treated. The research was conducted on samples taken from cold rolled ... -
The Influence of Cold Rolling on the Microstructure for Drawing Steels
(Universitatea "Dunărea de Jos" din Galați, 2007)The paper presents the structural changes that appeared in steel for deep drawing, as a result of cold rolling and of recrystallization thermal treatment. The research was conducted on samples taken from the rolled strap, ... -
The Influence of Different Coatings on the Grafhite Degeneration in the Superficial Layer of Iron Castings
(Universitatea "Dunărea de Jos" din Galați, 2014)The main objective of this experimenal reserch is to investigate new possibilities for reducing the graphite degeneration phenomenon in the superficial layer of iron castings. For the experiment, a spheroidal graphite ... -
The Influence of Moisture on Thermal Conductivity for Building Materials
(Universitatea "Dunărea de Jos" din Galați, 2017)The purpose of the study is to determine the influence of moisture on thermal conductivity for a range of building materials. A series of building materials and insulation materials have a porous, fibrous or granular ... -
The Influence of Nano-Particle Additive to Lubricating Oils on the Structure and Properties of Friction Surfaces
(UDJG, 2011)The article considers the influence of the additive in the lubricating oils Cermet, on tribological properties of a friction pair «cast iron – chrome», which is typical for the cylinder-piston unit of engines. It is shown ... -
The Influence of Nonlinear Behavior of Viscous-Elastic Element on Equipment Foundation with Dynamical Apply Stresses
(Universitatea "Dunărea de Jos" din Galaţi, 2006)This paper presents a dynamical analyze on the foundation of machine when are apply stresses such the beat (percussion) in nonlinear behavior of the viscous-elastic elements hypothesis. In this way can be evaluate (more ... -
The Influence of Nonlinear the Elastic Character of Viscoelastic Systems on the Dynamic Response of Mechanical Systems
(Universitatea "Dunărea de Jos" din Galați, 2010)Bridges and viaducts represent vital engineering structures which are component of terrestrial communication lines, therefore reducing their exposure to factor originating from natural or anthropogenic hazards has no ... -
The Influence of Polarization Tension of the Grading Over thin Layer Properties of TiN Deposed Through PDV Method
(Universitatea "Dunărea de Jos" din Galați, 2006)The deposits of tough thin layers on pieces and tools through PDV method knew a permanent and constant spreading owing to the great applicability of the resulting coatings which make that the thin layer deposit from the ... -
The Influence of Speed Cooling on Some Properties of Laminated Steel
(Universitatea "Dunărea de Jos" din, 2016)This study presents a possibility to predict the connection between the cooling regime and the properties of steel. An important factor to enhance the properties of steel is the speed of the cooling regime. To be in ... -
The Influence of Steam Treatment on Mechanical Properties and Abrasive Wear Behavior of Sintered P/M Steels
(Universitatea "Dunărea de Jos" din Galaţi, 2012)In this paper is a study of the influence of steam treatment on sintered P/M steels, for three different types of powder. The abrasive wear of steam-treated sintered iron is analysed by abrasion tests. The specimens were ... -
The Influence of the Applied Load on the Friction Coefficient of the Sintered Iron-Base Bearings
(Universitatea ”Dunărea de Jos” din Galați, 2008)In the recent years the iron base sintered bearings production was considerable increased at the expense of the copper based ones, due to the low cost and availability of the iron powders as well as the higher strength. ... -
The Influence of the Carbon Content on the Depth of the Carbonitrurat Layer in Fluidized Layer for 1C15, 1C25 and 1C45 Steels
(Universitatea "Dunărea de Jos' din Galați, 2016)This paper presents the experimental research of carbonitriding thermochemical processing in fluidized layer performed on some samples of carbon steel with different carbon contents, the fluidized layer being made up of ... -
The Influence of the Hydraulic Fluid Compressibility on the Tematics of Mechanisms Actuated with Hydraulic Cylinders
(Universitatea "Dunărea de Jos" din Galați, 2015)the description of the kinematics of mechanisms driven by hydraulic cylinders, hydraulic agent is usually considered incompressible. This computing hypothesis introduces errors which, in certain situations, can not be ... -
The influence of the physical-Chemical Factors on the Distribution of Heavy Metals in the Delta Ecosystems
(Universitatea "Dunărea de Jos" din Galați, 2015)Recognized to the influence of micropollutants, heavy metals represented on the ecological status of surface waters, including delta ecosystems, the paper aims to study the impact of environmental factors (temperature, ... -
The influence of the Rolling track on the Dynamic Comportment of the equipement on tyres
(Universitatea "Dunărea de Jos" din Galați, 2005)The paper presents aspects connected to the comportment of the vehicle on wheels which moves on dislevement soil. A complete dynamic model is realized for a vehicle on wheels with tyres, which wheels are rigidly tied to ... -
The Influence of the Sintering Atmospheres on the Wear Behaviour of the Copper Based Alloys
(UDJG, 2010)The Powder Metallurgy (PM) technique allows manufacturing the sintered selflubricating materials having a high wear resistance. It is well known that the small and medium sized bearings are processed by PM with better ...
