On a global scale one can notice a constant preoccupation for a rational choosing and using of the materials on the whole and, especially of the steels with the main objective the increase of the machines’, equipment’ ...

Multilayer cladding by injection of powder with 8.9% Cr, 4.5% Fe, 5.1% B, 2.4% Al, 0.6% Cu, Ni rest as chemical composition, in melted bath by a continuous wave CO2laser connected to x-y-z coordinate table was tested in ...

Multilayer coating by injection of powder with 8.9% Cr, 4.5% Fe, 5.1% B, 2.4% Al, 0.6% Cu; all reminded of Ni, as chemical composition, in melted bath by CO2 continuous wave laser connected to x-y-z coordinate table was ...

For the purpose of studying the possibilities of increasing the wear resistance, specimens of three steels with 0.2%C, 0.46%C and 1%C were surface alloyed with reinforcement from overlapping pastes with green SiC hard ...

The purpose of this paper is to study the influence of processing parameters on the microstructural characteristics of sintered powder metallurgy alloys. The specimens were produced from atomised iron powders with different ...

The paper is focused on modification of surfaces properties by laser cladding. To follow the corrosion behavior in different media of laser cladding layers made of nickel based alloy Ni - Cr - B - Fe - Al. It was studied ...

Progress reported over time in dentistry can be attributed largely to the dynamics of acquiring new materials. A biomaterial is considered ideal in the absence of any biomaterial-tissue interaction, which means a biomaterial ...

The article presents how to obtain porous bronze products using copper - based powder by powder metallurgy methods. The formation of tablets was done by free pouring the spherical powder into the mould, followed by their ...

The paper presents the structural changes that appeared in steel for deep drawing, as a result of cold rolling and of recrystallization thermal treatment. The research was conducted on samples taken from the rolled strap, ...