Căutare după Subiect "roughness parameters"
Afișează articolele 1-2 of 2
-
Profilometric Analysis of Worn Surface of Bronze, Iron and Iron Composite Samples, by Pin-on -Disk Method
(Universitatea "Dunărea de Jos" din Galați, 2013)In this study are presented the results of profilometric analysis for the wear of bronze materials, cast iron and composite materials. These materials were tested under dry wear conditions, using "pin-on-disk" method on ... -
Surface Roughness Parameters Evaluation in Rolling/Sliding Wear TestsS
(UDJG, 2011)Rolling/sliding wear tests were performed on an Amsler test rig. Normal load (expressed as the Hertzian pressure) and the roll-slide ratio have been considered to have the most important influence in simulating gear ...