Căutare 1993 -2018 după Autor "Gheorghieș, Constantin"

Afișează articolele 1-5 of 5

    • Characterization on the Red Mud Resulted from the Alumina Bayer Process Production for the Future Use in Geopolymers Synthesis 

      Spătaru (Severin), Ilenuța; Vlad, Maria; Gheorghieș, Constantin; Movileanu, Gelu (Universitatea "Dunărea de Jos" din Galați, 2014)
      This paper presents the results of analyses on the chemical, structural and morphological processing of bauxite red mud resulting from alkaline wet Bayer technology. The characterization of the material considered as ...

    • Laser Cladding of Ni-Cr-B-Fe_Al Alloy on a Steel Support 

      Levcovici, Sanda Maria; Levcovici, Dan Teodor; Gheorghieș, Constantin; Boiciuc, Simona (Universitatea "Dunărea de Jos" din Galați, 2005)
      Multilayer coating by injection of powder with 8.9% Cr, 4.5% Fe, 5.1% B, 2.4% Al, 0.6% Cu; all reminded of Ni, as chemical composition, in melted bath by CO2 continuous wave laser connected to x-y-z coordinate table was ...

    • On the Corrosion Behavior of Organic Nanocomposite Coatings 

      Gheorghieș, Constantin; Gheorghieș, Livia; Oancea, Constantin; Hagioglu, Petrica (Universitatea "Dunarea de Jos" din Galați, 2009)
      Recently, researches on composite coatings of organic nature with the addition of metallic oxide nanopowders have shown an increasing corrosion resistance of metallic materials. Carbon steel shows an improved behavior ...

    • A test for Rapid Tribological Characterization of Bearing Steels 

      Gheorghieș, Constantin; Buciumeanu, Mihaela; Scarpete, Dan; Gheorghieș, Livia; Bold, Dorian (Universitatea "Dunărea de Jos" din Galați, 2012)
      In this paper is a study the influence of the material and heat treatment on the changes of the fine structure parameters of the superficial layer of triboelements during the first cycles of rolling contact process. The ...

    • X-Ray Diffraction Residual Stress Measurements for Quality Control Testing 

      Gheorghieș, Constantin; Cantaragiu, Alina-Mihaela; Stasi, Iuliana Valentina (Universitatea "Dunărea de Jos" din Galați, 2007)
      This paper present the primary difficulties which are associated with the obtaining and interpreting surface X-ray diffraction residual stress results: the surface stresses may be identical for the shoot peening, nitriding ...